Telaire VOC Sensor Module

 

Telaire VOC Sensor Module

Telaire MiCS-VZ-89TE Integrated Sensor Board

The MiCS-VZ-89TE combines state-of-the-art MOS sensor technology with intelligent detection algorithms to monitor tVOCs and CO2 equivalent variations in confined spaces, e.g. meeting rooms or vehicle cabins.

The dual signal output can be used to control ventilation on-demand, saving energy and reducing cost-of-ownership.

Check Distributor Stock

Features

  • Calibration-free
  • Low power
  • Wide VOCs detection range
  • High sensitivity
  • High resistance to shocks and vibrations

Detectable Gases

  • Volatile Organic Compounds: VOCs
  • Equivalent Carbon Dioxide: CO2 (equivalent)

Specifications

 

Performance

Detection Method Semiconductor gas sensor, detecting a wide range of VOCs
Monitoring Range 400-2000 ppm equivalent CO2
0-1000 ppb isobutylene equivalent tVOCs
PWM Output Pin 1 : TTL output 30Hz +/-1%, Range 5...95%, duty cycle @ 3.3V
Use a pull-up resistance between Pin 1 and Pin 6
Pull-up value: typ. 10kOhms
I2C Output Pin 2 and 4 ; Pull-up of 4.7 kOhms on master SDA and SCL
Response Time Equivalent to conventional NDIR-CO2 sensors
< 5 seconds for tVOC
Refresh Output Frequency 1 Hz

 

Operation

Supply Voltage 3.3V DC regulated +/- 5% 
Operating Power 125 mW
Warm-up Time 15 min
Operating Temperature 0°C to 50°C
Operating Humidity 0%RH to 95%RH (non condensing)
Storage Temperature  -40°C to 80°C
Storage Humidity  0%RH to 95%RH (non condensing)

Important Precautions:

- The sensor must not be exposed to high concentrations of organic solvents, ammonia, silicone vapor or cigarette-smoke in order to avoid poisoning the sensitive layer.

- The sensor should be protected against water and dust projections.

- Telaire strongly recommends using ESD protection equipment to handle the sensor.

 

 
Copyright © 2017 Amphenol Corporation. All Rights Reserved.